Dating fender bass by serial christian ranchers dating
Consequently, some 1990 guitars bear 1999 “N9” SERIAL NUMBERS. American Deluxe Series instruments use the same dating convention, but with the addition of a “D” in front of the “Z”; i.e., DZ1, DZ2, etc.
“Z”-prefix SERIAL NUMBERS denoting the new millennium appeared on U. As always, there is typically some number prefix overlap and carryover from year to year.
The Fender serial number decoder currently supports all documented MIA, MIJ, MIM, MIK and MII formats with the exception of Custom Shop, Relic and Reissue instruments.
Please note that fender serial numbers tend to overlap by at least a year, and thereby the date of your guitar can only be approximated.
Most notably, PRODUCTION DATES have been penciled or stamped on the butt end of the heel of the neck of most guitars and basses, although there were periods when this was not consistently done (1973 to 1981, for example) or simply omitted.
instrument production history, PRODUCTION DATES have been applied to various components.
The “10” prefix was designed to identify the first year of the second decade of the new millennium, and while it appears on the instrument decals, it was not captured in Fender’s operating system.But once again, due to Fender’s modular production methods and often non-sequential serial numbering (usually overlapping two to four years from the early days of Fender to the mid-1980s), dating by serial number is not always precisely definitive.The chart below details Fender serial number schemes used from 1950 to 1964.Notice that there is quite a bit of overlap in numbers and years.The only way to try to narrow the date range of your specific instrument is to remove the neck and check the butt end of the neck heel for a production date, which may be stamped or written there (if you’re uncomfortable doing this yourself, please refer to an experienced professional guitar tech in your area). Serial numbering didn’t change immediately because instruments continued to be made using existing, tooling, parts and serial number schemes.
Neck-dating can be useful in determining the was produced, rather than the complete instrument.